Preparing Your Workstation - HP Visualize c3600 Upgrade Instructions

Getting Started

Preparing Your Workstation

Preparing Your Workstation
The workstation must be running HP-UX 10.20 or later with Additional
Core Enhancements (ACE4) 9906 to accommodate the PA8600 upgrade.
Use the command uname -r to determine the revision of your operating
system. It should report B.10.20. If the workstation is running an older
version of HP-UX, update the operating system software before
continuing. Use the command /usr/sbin/swlist -l bundle | grep ACE to
view what software products are loaded in your system. If the product
list includes B6193DA, you do not need to update HP-UX.
1. Determine the workstation's LAN ID by entering the following
command: /usr/sbin/lanscan.
The output is similar to the following:
Hardware Station
DLPI Mjr
Path Address
Num
2.0.2 0x08000970ECC0 0 UP
130
Record the LAN ID here. You will need it after installing the new
system board:
Enter LAN ID: ___ ___ ___ ___ ___ ___ -___ ___ ___ ___ ___ ___
You must supply the dash (-) between the first six digits and the last
six digits
After you install the new CPU board and power on the system for the
first time, you may be prompted for the LAN ID.
12
Crd Hardware Net-Interface NM MAC HP
In# State NameUnit State ID Type Support
lan0 UP 4 ETHER YES
Chapter 1