Power Cord; Speaker Leads - Pioneer DMH-W2770NEX Installation Manual

an external power amp's system remote
control terminal, the auto-antenna relay
control terminal, or the antenna booster
power control terminal (max. 300 mA 12
V DC). The control signal is output
through the blue/white lead, even if the
audio source is switched off.
This product
GPS antenna 3.55 m (11 ft. 8 in.)
Microphone 3 m (9 ft. 10-1/8 in.)
This product
Antenna jack
Connector 1 (REAR VIEW CAMERA IN/
MUTE/STEERING WHEEL CONTROL)
Connector 2 (AUX IN)
Pre out supply
SiriusXM Connect Vehicle Tuner
Be sure to use the SiriusXM cable
supplied with this product.
Refer to the installation guide for
SiriusXM Connect Vehicle Tuner (sold
separately).
Fuse (10 A)
Power supply
To connector 1
SWC/Back Camera cord
Wired remote input (STEERING WHEEL
CONTROL)
Hard-wired remote control adapter can
be connected (sold separately).
4
En
Brown (REAR VIEW CAMERA IN)
Yellow/black (MUTE)

Power cord

To power supply
Power cord
Yellow
To terminal supplied with power
regardless of ignition switch position.
Red
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF
Orange/white
To lighting switch terminal.
Black (ground)
To vehicle (metal) body.
Violet/white
Of the two lead wires connected to the
back lamp, connect the one in which
the voltage changes when the gear shift
is in the REVERSE (R) position. This
connection enables the unit to sense
whether the car is moving forward or
backward.
Pink
Car speed signal input
Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
parking brake. This lead must be
connected to the power supply side of
the parking brake switch.
Power supply side
Parking brake switch
Ground side
NOTE
The position of the speed detection circuit
and the position of the parking brake
switch vary depending on the vehicle
model. For details, consult your authorized
Pioneer dealer or an installation
professional.

Speaker leads

To power supply
Power cord
Left
Right
Front speaker
Rear speaker
White
White/black
Gray
Gray/black
Green
Green/black
Violet
Violet/black
NOTE
With a two-speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.