DeLonghi DDX2 Series Instructions For Use Manual page 9

TROUBLESHOOTING
Check the following points before calling your local Customer Service Center.
PROBLEMS
The appliance is operating in
dehumidifying mode, but the
humidity does not decrease.
The appliance does not work for 3
minutes after start-up.
is displayed
is displayed
"E2"/"E3" is displayed
"PUMP" symbol blinking
CAUSE
The filters are blocked.
The temperature or humidity in the
room are too low.
Too many sources of humidity in the
room (pots of boiling water, etc.).
The humidy set point is too high.
The safety device has tripped.
The tank is missing.
The tank is full.
The tank is incorrectly positioned.
The temperature in the room is very
low.
One of the sensors on the appliance
is faulty.
The pump tube (9) is missing or
clogged or blocked.
9
SOLUTION
Clean the filters.
In certain conditions, it is normal for
the appliance not to dehumidify (in
certain cases, it is recommended to
heat the environment).
Eliminate as many sources of humidi-
ty as possible.
Decrease the humidity set point.
Wait for 3 minutes to pass.
Replace the tank.
Empty the tank.
Position the tank correctly.
Increase room temperature.
Call the Customer Service Center.
Check the hose is correctly positioned
or unclogged, To reset the alarm
disconnect and reconnect the plug.
If the problem persists, call the Cus-
tomer Service Center.