HP Vectra VT6 Supplementary Manual page 27

Installing a Hard Disk
Drive in an Internal Shelf
All models have an integrated IDE controller. All models of HP Vectra XU 6/
xxx PC have an integrated SCSI controller.
• The Enhanced IDE controller supports up to four IDE devices:
two IDE devices (HDD recommended) can be connected to the
Primary Channel cable (the grey connector on the system board).
two IDE devices (CD-ROM recommended) can be connected to the
Secondary Channel cable (the red connector on the system board).
• The SCSI controller on the HP Vectra XU 6/xxx PC supports up to seven
SCSI devices (up to five SCSI devices can be connected to the internal
SCSI cable).
Each hard disk drive ordered from HP is supplied with a mounting tray.
To mount a drive from another supplier, you may need to order a mounting
tray from HP (D2037A, 3.5-inch hard disk mounting tray).
1 Align the drive (upside down) with the hinges on the shelf, then insert it
into the hinges.
2 Rotate the drive over, into position, using the hinges as the pivot.
3 Secure the drive using the screw provided.
2 PC Hardware Structure
Installing or Replacing Accessories
two internal shelves
for hard disks
two shelves for 3.5-inch disk
drives
three shelves for 5.25-inch disk
drives
IDE connected to the Primary IDE
channel cable (grey connector)
SCSI drives connected to any
connector on the SCSI cable
(XU only)
23