HP Vectra VT6 Supplementary Manual page 20

Replacing the Cover
2 PC Hardware Structure
Packaging
To put the cover back, reverse the steps which were followed when removing
the cover. However, there are a number of points where care is needed:
1 Check that cables will not be snagged when the power supply and the
cover slide back into place.
2 Replace the airflow guide above the processor socket, pivoting it on the
lower edge of the cooling fan housing.
3 Check that the cover is unlocked and that the latches are outwards.
4 When you place the cover in front of the computer, ensure that the two
lips at the bottom of the case slide on to the two rails at the base of the
computer.
5 When you slide the cover back into position, make sure that it does not
jam against the plastic clips on the right bezel.
6 Ensure that the CD-ROM drive aligns correctly with the holes in the front
panel. For the final couple of centimeters of travel, place the palm of your
hand over this panel to prevent it from being pushed out by the CD-ROM.
7 Push the two latches at the front of the cover down, until they click into
position. Lock the cover at the back with the key, if required.
16