Before Washing For The First Time; Transportation - Bosch WGG254A0SG Instruction Manual And Installation Instructions

Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Û Drum Clean programme the first
time without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 12
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the Û Drum Clean 90°C
4.
programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
manual dosing compartment.
Add standard detergent to manual
7.
dosing compartment according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
8.
Select Start/Reload A.
9.
When the programme ends, turn the
10.
programme selector to Off.
Your appliance is now ready for use.
Positioning and connecting

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 43
Drain any residual water.
3.
~ Page 42
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.
en
19