HP Vectra VE5 4 Installation Manual page 9

Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.
• Windows 95 SR2 media.
• Novell Netrware 4.11 server that supports Net BEUI, NWLink IPX/SPX,
Device Configuration
• I/O Base Address
• Interrupt Request Level
• Boot PROM
• Transceiver Type
• Network Driver Optimization
• Maximum Modem Speed
• Plug and Play Compatibility
• Full Duplex
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C509-B
2 Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3 Insert the 3COM drivers diskette (ver. 5.0 downloaded from 3COM's
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and restart the machine.
7 After windows loads, click on "Start," to "Settings" and over to "Control
8 Double click on "Network" and select "Add."
File Name: Elnk3.VXD Size: 30KB Date: 7/18/96
and NWLink NetBIOS transfer protocols.
adapter card into an ISA slot.
website) and execute 3C5X9CFG.EXE.
under the heading "Device Configuration."
Panel."
2 Connecting to a Netware 4.11 Server
300
10
Disabled
Auto Select
Windows or OS/2 Client
9600 Baud
Disabled
Disabled
Windows 95 SR2