HP Vectra VE5 4 Installation Manual page 21

Windows NT Requirements
Workstation 4.0
• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver 5.0.
• Microsoft Windows NT Workstation 4.0 and service pack media.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
Device Configuration
• I/O Base Address
• Interrupt Request Level
• Boot PROM
• Transceiver Type
• Network Driver Optimization
• Maximum Modem Speed
• Plug and Play Compatibility
• Full Duplex
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B
2 Connect network media to the 3COM 3C509B card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Etherlink 3C509-B Ethernet card and
5 Select "CONFIGURE NIC", and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3com cards driver diskette and reboot the machine.
Driver Name: Elnk3.SYS Size: 27KB Date: 7/18/96
(If you have a Hewlett-Packard pre-loaded HDD, the media is located at
"C:\I386")
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
adapter card into an ISA slot.
drivers disk ver 5.0. and execute "A:\3C5X9CFG.EXE."
under the heading "Device Configuration."
3 Connecting to a Windows NT Server 3.51
Windows NT Workstation 4.0
300
10
Disabled
Auto Select
Windows or OS/2 Client
9600 Baud
Disabled
Disabled