Assembly - Husqvarna 543 XP Operator's Manual

not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the guide bar and saw
chain
1. Disengage the chain brake.
2. Remove the bar nuts and the clutch cover. Remove
the transportation guard (A).
3. Assemble the guide bar onto the bar bolt. Move the
guide bar to its most rear position.
956 - 007 - 10.05.2022

Assembly

Read and understand the
A
4. Install the saw chain correctly around the drive
sprocket and put it in the groove on the guide bar.
WARNING:
gloves when you assemble the saw
chain.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nut finger tight.
Always use protective
9