After Closing The Pc; Removing The Side Panel - HP Pavilion t348 User Manual

after closing the pc

To avoid injury and equipment damage, always follow this procedure in this
order after closing the PC:
1 Reconnect the power cord and all other attached cables (such as the keyboard,
mouse, and monitor).
2 Reconnect the modem/telephone cable.
3 Turn on the PC and all peripherals.
4 If you installed an add-in card, install any software drivers supplied by the
card manufacturer.

removing the side panel

1 See "before opening the pc" on page 104.
2 Loosen the two thumbscrews on the right side of the back panel. The first
time you loosen these screws, you may need to use a Phillips screwdriver.
These screws do not detach; they stay on the side panel loosely until you
tighten them again.
3 Pull the panel back toward you until it stops. Lift the panel off the chassis and
set it aside.
NOTE:
You do not need to remove the other side panel to replace the hardware
listed in this guide.
upgrading and servicing the pc (1)
105