Table of Contents
Advertisement
Multi-Storage Bay - Peripheral Placement
To use the multi-storage bay for a
peripheral device, do the following:
1 Open the bay cover. Hold the
cover on each side near the
hinges, then lift the cover and
slide it toward the back of the
chassis (figure C). Gently lift
it off.
2 Thread the cables through the
cable tunnel opening at the back
of the bay (figure D). Connect
data and power cables to the
peripheral device, and place
the peripheral in the bay.
3 Connect the data cable to the
USB or FireWire connector on
the back of the PC. Plug the
power cord into a power outlet.
Your PC may look different from
the one shown here. Component,
connector location, type, and
number vary by model.
C
D
Quick Start Guide
xi
Advertisement
Table of Contents
