Finisher: Add Staples; Get Access To The Staplers - Canon VarioPrint 6000 Series Operation Manual

Finisher: Add staples

Introduction
The optional finisher
The finisher contains 2 staplers. Both staplers are located inside the finisher. Stapler 1 is located
at the back side. Stapler 2 is located at the front side.
This section describes how to add staples.
NOTE
You can add short and long staples. It is important to add the correct staples. Use short staples if
your documents contain fewer than 50 sheets. Use long staples when your documents contain
more than 50 sheets. Only use staples of type S25 (long staples) or S37 (short staples).
When to do
When a staple cartridge is empty or almost empty
page 310.

Get access to the staplers

Procedure
1. Open the front door of the finisher.
2. Open top cover E1.
3. Open cover E5.
4. Lock cover E5 with the locking mechanism E6.
5. If required, slide stapler 1 to the centre. This makes the access to the cartridge holder in stapler 1
easier.
VarioPrint 6000 line
The output locations on page 21
on top of the stacker can staple your jobs.
Check the status of the stapler cartridges on
Chapter 12 - Maintain the print system
Finisher: Add staples
311