Lithium Battery Caution; Laser Safety Statement; Tv Antenna Connectors Protection - HP Pavilion a250 Regulatory And Safety Information Manual

Warning: For your safety, always unplug the system from
its power source and from any telecommunications systems
(such as phone lines), networks, or modems before
performing any of the procedures described in this guide.
Failure to do so may result in personal injury or equipment
damage. Hazardous voltage levels are inside the power
supply and modem of this product.

Lithium Battery Caution

Warning: The PC uses a lithium battery, type CR2032.
There is danger of an explosion if the battery is incorrectly
replaced. Replace only with the same, or equivalent, type
recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.

Laser Safety Statement

Class 1 LED Product
The CD-ROM and DVD-ROM drives contain a laser system and are classified as a
"Class 1 Laser Product" under a U.S. Department of Health and Human Services
(DHHS) Radiation Performance standard according to the Radiation Control for
Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an authorized service location.
Warning: Use of controls, adjustments, or performance
procedures other than those specified in the Upgrading and
Servicing the PC guide may result in hazardous radiation
exposure. To prevent direct exposure to laser beam, do not
try to open the enclosure of the CD-ROM or DVD-ROM.
Laser Product Label
The following label or equivalent is located on the surface of HP laser products:

TV Antenna Connectors Protection

External Television Antenna Grounding
If an outside antenna or cable system is connected to the product, be sure
the antenna or cable system is electrically grounded so as to provide some
protection against voltage surges and built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA 70, provides information with regard to
This label indicates that the product
is classified as a CLASS 1 LASER PRODUCT.
This label appears on a laser device
installed in your product.