Page 3
Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
Page 5
10. Make sure that the total amperes of all the units that are plugged into a single wall outlet do not exceed 15 amperes. 11. Never push objects of any kind into this unit through the cabinet ventilation slots, as they may touch dangerous voltage points or short out parts that could result in risk of fire or electric shock.
Datavideo office. All non-Datavideo manufactured products (product without Datavideo logo) have only one year warranty from the date of purchase. Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.
Drive, Lighting, Camera module, PCIe Card are covered for 1 year. The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase. Disposal...
With the 56V power connected to one end of the HBT-16 HDBaseT receiver, the HBT-16 will thus be able to power the transmitter by Power over Ethernet (PoE). On the transmitter end (HBT-15), there is also a 12V/30W DC output serving to supply power to backend devices.
HDMI port for video input. DVIP Port Connects to devices such as PTC-150 camera, serving as a communication port between the connected device and the HBT-15 transmitter. DC OUT 12V 30W DC power supply Power LED Indicator ON: Supplying power...
Note: Visit https://hdbaset.org/hdbaset- recommended-cables/ for cable recommendations. RS-232/RS-422 Interface The RS-232/RS-422 port connects HBT-15 directly to Datavideo’s cameras such as PTC-150. Use the RS- 232 or RS-422 custom cable to connect. See 232/RS-422 pinout for more information about the respective cabling.
4. RS-232/RS-422 Pinout The Datavideo’s PTZ Camera can be connected to the HBT-15 Transmitter box through the RS-232 or RS-422 interface using a custom Ethernet cable. The respective connection wiring schemes are shown below. RS-232 HBT-15 Transmitter Box PTZ Camera...
Page 13
RS-422 HBT-15 Transmitter Box PTZ Camera White/Orange White/Orange Orange Orange White/Green White/Green Blue Blue White/Blue White/Blue Green Green White/Brown White/Brown Brown Brown...
5. Dimensions All measurements in millimeters (mm) 6. Specifications Video / Audio Input HDMI 2.0 x 1 Output HDBaseT RJ-45 x 1 2160p60/59.94/50/30/29.97/25 1080p60/59.94/50/30/29.97/25 Supported 1080i60/59.94/50 Resolutions 720p60/59.94/50 480i59.94 576i50 Control DVIP Ethernet RJ-45 x 1 RS-422 / RS-232 RJ-45 x 1 Power DC OUT DC 12 V 30W...
Page 15
Storage -20 – 60°C (-4°F – 140°F) Temperature Humidity 10% to 80% (non-condensing) HDBaseT Video transmission at 2160p60/59.94/50 for Up to Transmission 100m using the CAT. 6A Cable (lower resolutions are Distance also supported)
Page 16
Service and Support www.datavideo.com/product/HBT-15 Datavideo Technologies Co., Ltd. All rights reserved 2020 Jan-17.2022 Ver: E1...