Page 3
Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
Page 5
10. Make sure that the total amperes of all the units that are plugged into a single wall outlet do not exceed 15 amperes. 11. Never push objects of any kind into this unit through the cabinet ventilation slots, as they may touch dangerous voltage points or short out parts that could result in risk of fire or electric shock.
Datavideo office. All non-Datavideo manufactured products (product without Datavideo logo) have only one year warranty from the date of purchase. Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.
Drive, Lighting, Camera module, PCIe Card are covered for 1 year. The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase. Disposal...
1. Introduction The HBT-10 and HBT-11 are respectively the HDBaseT transmitter and receiver with a maximum allowable transmission distance of 120 meters. The transmitter allows transmission of up to 4K image quality video. With the 48V power connected to one end of the HBT-11 HDBaseT receiver, the HBT-11 will thus be able to power the transmitter by Power over Ethernet (PoE).
3. Connections Rear Panel HDMI IN HDMI port for video input. DVIP Port Connects to devices such as PTC-150 camera, serving as a communication port between the connected device and the HBT-10 transmitter. DC OUT 12V 30W DC power supply Power LED Indicator ON: Supplying power OFF: Power disconnected...
Front Panel HDBaseT Port Connects between HBT-10 transmitter and HBT- 11 receiver using any standard Ethernet cable. RS-232/RS-422 Interface (Phoenix Terminal) Connects to external RS-232/RS-422 device. RX: Receiver PIN (differential pair if using RS-422 connection) TX: Transmitter PIN (differential pair if using RS- 422 connection) G: Ground PIN Note: See...
Page 12
Cable Selection section for cable recommendations. In addition to HBT-11, you can also connect to any of Datavideo’s HDBaseT product range in 4K or long reach mode. The table below provides information about the available connection modes for connecting to other HDBaseT devices.
4. RS-422 Pinout The PTC-150 PTZ Camera can be connected to the HBT-10 Transmitter box through the RS-422 interface. The RS-422 connection wiring scheme is shown below. HBT-10 Transmitter Box PTC-150 Camera White/Orange White/Orange Orange White/Green White/Green Blue Blue White/Blue White/Blue Green Green...
Operating 10% – 80% Relative Humidity HDBaseT 1080p60 Up to 120M by Cat. 6 Cable; Transmission 2160p30 Up to 70m by Cat. 6 Cable Distance Cable Selection Video Resolutions (HBT-10/HBT-11 Pair ONLY) Cable Range Video Resolution Up to 1080p, 60Hz, 36 bpp. 120 meters Data rates lower than 5.3 Gbps CAT5e/6...