Yamaha YXZ1000R 2020 Service Manual page 14

[To enter the shift light control mode]
1. Turn the key to "
2. Push and hold the "MODE" button.
3. Turn the key to "
the "MODE" button after all segments of the
display disappear and the shift light comes
on. The shift light can be adjusted as follows.
[To set the flashing pattern]
1. Push the "RESET" button to select one of the
following flashing pattern settings:
• On: the shift light stays on when activated.
(The shift light will confirm this setting by stay-
ing on.)
• Flash: the shift light flashes when activated.
(The shift light will confirm this setting by
flashing four times per second.)
• Off: the shift light is deactivated; in other
words, it does not come on or flash. (The shift
light will confirm this setting by flashing once
every two seconds.)
2. Push the "MODE" button to confirm the se-
lected flashing pattern. The control mode
changes to the activation point setting mode.
The shift light remains on and the tachometer
shows the current setting r/min for the activa-
tion point.
[To set the shift activation point]
TIP
• The shift light activation point can be set be-
tween 7000 r/min and 12000 r/min. The activa-
tion point can be set in increments of 500 r/min.
• The tachometer needle will start over at 7000 r/
min after 12000 r/min.
1. Push the "RESET" button to select the de-
sired engine speed for activating the shift
light.
2. Push the "MODE" button to confirm the se-
lected engine speed. The shift light flashes
and the tachometer shows the current setting
r/min for the deactivation point.
[To set the deactivation point]
TIP
• Be sure to set the deactivation point to a higher
engine speed than for the activation point, oth-
erwise the shift light will not come on.
• The shift light deactivation point can be set be-
tween 7000 r/min and 12000 r/min. The deac-
tivation point can be set in increments of 500 r/
min.
" (off).
" (on), and then release
• The tachometer needle will start over at 7000 r/
min after 12000 r/min.
1. Push the "RESET" button to select the de-
sired engine speed for deactivating the shift
light.
2. Push the "MODE" button to confirm the se-
lected engine speed. The display exits the
shift light control mode and returns to the
standard multi-function display mode.
Fault code display (YXZ1000E)
1. Fault code display
2. Engine trouble warning light "
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If a problem is detected in any of those circuits,
the engine trouble warning light will come on or
flash, and the display will indicate a fault code.
If the display indicates a fault code, note the
code number, and then check the fuel injection
system.
Refer to "FUEL INJECTION SYSTEM" on page
9-43.
ECB02030
NOTICE
If the display indicates a fault code, the vehi-
cle should be checked as soon as possible
in order to avoid engine damage.
Fault code display (YXZ1000ET/YX10ZXPSL)
1
1. Fault code display
2. YCC-S system fault code display
1-5
FEATURES
1 2
"
2 3 4