Table of Contents
Advertisement
2.9
Specifying the Batch Separation Settings
This section describes how to specify the Batch Separation settings.
There are two ways to specify when a batch separation is performed:
• When a blank page is detected
• When a patch code sheet is detected
When a blank page or patch code sheet is detected, the scanned image file is
automatically separated into batch files.
The procedure below demonstrates setting the Batch Separation settings from the
E-mail screen, but the procedure is the same for all the Scan Kiosk II V2.0 user
functions.
IMPORTANT
• To enable the Batch Separation settings, the Scan Kiosk Administrator must enable
the Counter setting on the Custom File Name Settings screen. For more information,
see your Administrator.
• In addition, you must set the Auto file name to 'Custom' from the Send Settings
screen. For more information, see
• The Home screen only shows [E-mail] if a mail server has been configured.
1. From the Scan Kiosk II V2.0 Home screen, press [E-mail].
The Address selection screen appears.
104
"Specifying the Scan and Send Settings,"
on p. 65.
Scan Kiosk II V2.0 User's Guide
Advertisement
Table of Contents
