HP Ultrium Configuration Manual page 28

In the file
1.
/kernel/drv/st.conf
########
# Copyright (c) 1992, by Sun Microsystems, Inc.
#ident
add the following depending on which version of operating system you are installing (there are
6 significant spaces between HP and Ultrium in line 2):
for Solaris 8 without st patch:
for Generation 1 drives:
tape-config-list =
"HP
HP_LTO_GEN_1 = 1,0x36,0,0xd639,4,0x00,0x00,0x00,0x40,3;
name="st" class="scsi"
where is the SCSI target address of the device you have attached,
X
or, for Generation 2 drives:
tape-config-list =
"HP
HP_LTO_GEN_2 = 1,0x36,0,0xd639,4,0x00,0x00,0x00,0x42,3;
name="st" class="scsi"
for Solaris 9 and 10 (and 8 with st patch):
for Generation 1 drives:
tape-config-list =
"HP
HP_LTO_GEN_1 = 2,0x3B,0,0x18659,4,0x40,0x40,0x40,0x40,3,60,1200,
600,1200,600,600,18000;
name="st" class="scsi"
where is the SCSI target address of the device you have attached.
X
See "HP-Data Values" on page 29
or, for Generation 2 drives:
tape-config-list =
"HP
HP_LTO_GEN_2 = 2,0x3B,0,0x18659,4,0x42,0x42,0x42,0x42,3,60,1200,
600,1200,600,600,18000;
name="st" class="scsi"
2. If you are replacing an existing tape device on the same SCSI ID, remove the contents of the
/dev/rmt
% cd /dev/rmt
% rm *
28 Sun Systems, Solaris 8, 9, 10
"@(#)st.conf 1.6
Ultrium 1","HP Ultrium LTO 1","HP_LTO_GEN_1";
target=X lun=0;
Ultrium 2","HP Ultrium LTO 2","HP_LTO_GEN_2";
target=X lun=0;
Ultrium 1","HP Ultrium LTO 1","HP_LTO_GEN_1";
target=X lun=0;
Ultrium 2","HP Ultrium LTO 2","HP_LTO_GEN_2";
target=X lun=0;
directory as follows:
, after these lines:
93/05/03 SMI"
below for the values of the parameters in these lines.