Removing Add-In Cards; Replacing Add-In Cards - HP Media Center,Pavilion Media Center m200 Hardware Manual

Removing Add-In Cards

w
1
Disconnect any external and internal cables attached
to the card.
Be careful of the
2
sharp edges on
Loosen the screw on the bracket of the card you are
the expansion
replacing.
slot cover.
3
Hold the metal bracket and the far top corner of the
card. Carefully remove the card by pulling the card
straight out of the expansion slot.
w

Replacing Add-In Cards

Do not overload
1
Insert the new card into the slot and push straight
the PC by
down. Make sure the card is properly seated.
installing add-in
2
cards that draw
Attach the screw to secure the card you have
excessive current.
replaced.
The chassis is
3
designed to
Connect any internal cables to the card.
provide 2 amps
(average) of +5 V
power for each
board or card in
the chassis. The
total +5 V current
draw in a fully
loaded chassis
(one with all
add-in card slots
filled) must not
exceed the total
number of slots
multiplied by
2 amps.
58