HP Media Center,Pavilion Media Center m200 Hardware Manual page 65

Removing a memory module
1
Remove the fan duct. (See page 48.)
2
Locate the memory sockets on the motherboard.
Move any cabling out of the way, if necessary.
3
Push down the two retaining clips on the ends of
the socket until the memory module pops out of the
socket.
4
Holding the memory module by its top edge or
side edges only, lift it away from the socket. Store
it in antistatic packaging.
Installing a memory module
1
Push down the two retaining clips on the ends of the
memory socket.
2
Holding the new memory module by its top edge
or side edges only, remove it from the antistatic
packaging.
3
Position the memory module in alignment with the
socket (the one or two small notches on the lower
edge of the module fit into the raised bumps in the
socket). Push straight down on top of the memory
module until it is fully seated in the socket. The socket
retaining clips automatically lock it into position when
the memory module is fully seated.
4
Replace the fan duct. (See page 48.)
w
Do not pull the
memory module
out of the socket.
Use the retaining
clips to eject the
module.
n
Avoid touching
the memory chips
or the gold
contacts on the
module.
57