Replacing The Fan And Speaker Assembly - HP Kayak XU800 Installing And Replacing Hardware Manual

Removing the Fan
and Speaker
Assembly

Replacing the Fan and Speaker Assembly

1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front upper and lower bezels.
Refer to page 3 for these instructions.
3 Disconnect the cables from their connectors located on the system
board.
4 For ease of installation, place the PC Workstation on its side with the
system board facing upwards.
5 Remove the PC chassis retaining bar.
6 For Kayak XU800 PC Workstations, remove the Memory Expansion
Card. If required, refer to page 14 for instructions.
7 Remove the screw from the front of the chassis.
8 Unclip the three clips on the front of the chassis.
9 Slide the fan and speaker assembly towards the rear of the PC until it is
clear of the chassis, then remove it from the PC Workstation.
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Fan and Speaker Assembly
37