HP Kayak XA-s02 Install Manual page 26

Completing the
Installation of a
Processor
NOTE
NOTE
HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC
Workstation
Installing a Processor
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor
to verify which bus and processor speeds are supported.
Switch 1 Switch 2
1
UP UP
UP UP
UP UP
UP UP
UP UP
1. UP=OFF, DOWN=ON.
2 Install any other accessories before completing the installation of
the processor.
3 Replace the cover (see page 4).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
26 English
Switch 3 Switch 4
UP DOWN
UP DOWN
DOWN UP
DOWN UP
DOWN DOWN
Switch 5 Bus
Speed
UP 66 MHz
DOWN 66 MHz
UP 66 MHz
DOWN 66 MHz
UP 66 MHz
Processor
Speed
333 MHz
350 MHz
400 MHz
450 MHz
500 MHz