Using Scsiselect With Scsi Devices - Compaq Evo D310 MT Hardware Reference Manual

Using SCSISelect with SCSI Devices

✎
Hardware Reference Guide
The SCSI host adapter includes the SCSISelect utility to configure the
host adapter and to run SCSI disk utilities. To run the SCSISelect
utility:
I
In Post Messages Enabled mode: Press
Press <Ctrl><A> for SCSISelect Utility message displays
during POST.
I
In Post Messages Disabled mode: When the Compaq logo screen
displays, press any key to exit the logo screen. Immediately after
exiting the logo screen, press
utility.
A menu displays with the following options:
I
Configure/View Host Adapter Settings
❏
SCSI Bus Interface Definitions
N
Host Adapter SCSI ID
N
SCSI Parity Checking
N
Host Adapter SCSI Termination
❏
Additional Options
N
Boot Device Options
N
SCSI Device Configuration
N
Advanced Configuration Options
I
SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
For additional information about configuring POST message
display status, refer to the Computer Setup (F10) Utility Guide on the
Compaq Documentation Library CD.
Hard Drive Installation Guidelines
when the
Ctrl+A
to access the SCSISelect
Ctrl+A
B–7