Table of Contents
Advertisement
LCD/Display Elements
1
2
3
4
5
Note: Use the Plus (+) or Minus (-) above the Menu button to adjust any of the Menu options. Axiom automatically exits the Menu
settings after 20 seconds with no activity; or, simply press the OPERATE button at any time to exit the Menu.
1. Signal Strength
Indicator—directional bar graphs
indicates both signal strength and polarity (i.e. high
tones to the right; low tones to the left).
2. Iron
Check—Indicates that Axiom's Iron Check
feature is in use (see page 19).
3.
Mode—Indicates which detection mode is currently
selected. Select from Fine, Normal, Large or Salt.
4. Frequency
Scan—Use to automatically select
the quietest detecting frequency when audio
response is erratic due to EMI. When FREQ SCAN is
highlighted, press Plus (+) Menu button to begin
the scan or Minus (-) button to exit the scan. Takes
approximately 45 seconds.
5.
Tone—Scroll through 00 to 99 to select your pre-
ferred audio tone.
6. Audio
Type—Select 0 for PWM audio or 01 for VCO
audio (see page 14).
7.
Sensitivity—Indicates current Sensitivity setting.
14
15
6
13
12
7
8
9
8. Battery
Level—Shows status of battery life (25%
per segment). Recharge battery when one segment
remains.
9.
Speed—Select Slow, Medium or Fast detection
speed (see page 17).
10. Ground
Track—Select Off, Slow, Medium or Fast
continuous ground tracking speeds (see page 22).
11.
Backlight—Indicates LCD Backlight is on.
12. Wireless
headphones—Wireless icon flashes while
attempting to pair. Wireless icon is solid when unit is
paired with headphones.
13. Gnd Balance
Arrows—Indicates the trending
direction of ground balance when Gnd Track is on.
14. Gnd Balance
Indicator—Displays while performing
ground balance.
15. Ground Balance
Values—are shown by the upper
and lower 2-digit numbers.
11
10
7
Advertisement
Table of Contents
