Removing The System Board Tray - Compaq PW5100 Reference Manual

Removing the System Board Tray

The slide-out system board tray allows you to quickly remove the system board
without using tools.
To remove the system board tray:
1. Turn off the workstation and any external devices.
2. Disconnect the power cord from the electrical outlet.
3. Remove the workstation cover.
4. Remove the expansion board cage.
5. Disconnect all cables from the system board, and disconnect any
external device cables from the rear panel.
6. Grasp the back edge of the system board tray and slide it out of the chassis.
Figure 7-11.
IMPORTANT:
Guidelines for Expansion Board Cage Replacement" earlier in this chapter.
CAUTION: Before removing the workstation cover, ensure that
the workstation is turned off and that the power cord is
disconnected from the electrical outlet.
Removing the system board tray
Before replacing the expansion board cage, read "Important
Compaq Professional Workstation 5100 Reference Guide
7-15