Installing Add-On Cards - ECS L4S5M Manual

3. Plug the correct connector on the FDD cable for the 5.25-inch or 3.5-inch drive
into the FDD connector (B).
4. Plug a power cable from the case power supply into the power connector on
the FDD (C).
When you first start up your system, go immediately to the Setup Utility to
configure the floppy diskette drives that you have installed. See Standard
CMOS Features on page 27 for more information.

Installing Add-on Cards

This mainboard has three 32-bit PCI (Peripheral Components Interconnect)
expansion slots, one 4xAGP slot, and one Communications and Networking
Riser (CNR) slot.
PCI Slots PCI slots are used to
install expansion cards
that have the 32-bit
PCI interface.
4xAGP The 4xAGP slot is used
Slot to install a graphics
adapter that supports
the 4xAGP
specification and has a
4xAGP edge
connector.
CNR Slot This slot is used to
insert CNR cards with
Modem and Audio
functionality.
Note: Before installing an add-on card, check the documentation for the card
carefully. If the card is not Plug and Play, you may have to manually
configure the card before installation.
Follow these instructions to install an add-on card:
1. Remove a blanking plate from the system case corresponding to the slot you
are going to use.
2. Install the edge connector of the
add-on card into the expansion
slot. Ensure that the edge
connector is correctly seated in
the slot.
3. Secure the metal bracket of the card to the system case with a screw.
ATX1
1
COM2
1
CDIN2 LMDN1
CDIN1
JP2
FLOPPY1
AGP Slot
PCI1
PCI Slots
PCI2
PCI3
CNR1
CNR Slot
Edge
connector
16
AGP1
LUSB1
1
1
1
PWRFAN1 J3 W O M 1
Add-on
card