Table of Contents
Advertisement
VIP-Series Voice Integration Package Installation/Operation Manual
4.2.1
Input User Message 3 From the Aux Audio Input
Follow these steps to input user message 3 into the VIP-VCM:
Note: Refer to the FACP's installation manual section 7 for detailed programming information.
1. Wire a speaker cable with 1/8" mini plug (Radio Shack Cat. No. 42-2454) to Aux Audio
GND and IN terminals. Refer to Figure 4-3.
2. Plug the mini plug into the Line Out/Headphone jack on a PC or Laptop. See Figure 4-3.
3. Enter programming mode at the main control panel.
4. Select option 9 VIP-VCM Maint.
5. Select option 2 Local Recording.
6. Select which module you wish to have the playback from.
7. Select the circuit on the selected module you wish the playback to be from.
8. Press switch 2 and start playing the audio file from your PC at the same time.
See Figure 4-4.
This is a menu of
what the VIP-VCM
switch functions
look like.
Note: If a message is already stored in user message 3 memory location, then the message played on the aux
audio channel will only play and not record when switch 2 is pressed. See Table 4-2.
9. When the audio file from the PC is finish playing press switch 2 again.
4-4
Figure 4-3 Aux Audio Connection for Recording
Figure 4-4 Recording Options Window of FACP
Plug in here
53796
Advertisement
Table of Contents
