Table of Contents
Advertisement
3.4.3
Recessed Mounting
This section describes how to recess mount the cabinet into a wall. To recess mount the
cabinet you will need to have the optional trim ring P/N VIP-TR (ordered separately).
Follow these steps to recess mount the cabinet:
1. Remove the cabinet door and the dead front panel. See Section 3.4.3.1.
2. Cut a recess hole 20-¼" W x 26-¾" H (51.44 cm W x 67.95 cm H). There should be 1.5"
to 1.75" of cabinet extruding from the wall, this should be measured from either the top
edge or bottom edge to the exterior side of the sheet rock. (See Figure 3-3).
Do not insert the cabinet deeper than recommend above. If the cabinet is mounted to deep you will not be able
to re-attach the door assembly.
3. Mount the cabinet to wall studs by inserting a screw through the cabinets side mounting
holes into the wall stud.
Trim Ring
Trim Ring
Mounting
Hole
Side View of Cabinet
and Trim Ring
53796
Important!
Cabinet
Mounting Hole
Trim Ring
Mounting
Hole
Figure 3-3 Detail of Flush Mounting with Trim Ring
Sheet Rock
1.5 to 1.75"
Installation
Mounting
Studs
Cabinet
Mounting Hole
Sheet Rock
3-5
Advertisement
Table of Contents
