Cannot Print Properly From The Digital Camera - Canon PIXMA iP90 Quick Start Manual

Troubleshooting

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still
camera or digital video camcorder*, and the countermeasures to eliminate them.
* Hereafter, a digital still camera and digital video camcorder are collectively called a digital camera or camera.
Camera Error Message
Printer in use
Printer warming up
No paper /Paper error
Paper Jam
Printer cover open
No Print Head
Waste tank (Waste ink
2
absorber* ) full
Ink tank is empty
Printer error
1
* To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue.
2
* The waste ink absorber absorbs ink used during cleaning.
82
Possible Cause
Images are being printed from
the computer
The printer is warming up
No paper is loaded
A paper jam occurrs in the
printer
The Print Head Cover is open
No Print Head is installed (The
POWER lamp on the printer
flashes five times)
The Print Head is defective
(The POWER lamp on the
printer flashes five times)
2
The waste ink absorber*
nearly full
Replace the ink tank with a
new one
The battery level is low (The
POWER lamp on the printer
flashes twelve times)
An error requiring servicing
might have occurred (The
POWER lamp on the printer
flashes alternately orange and
green)
Wait until printing ends. The printer automatically starts
printing the images from the camera after completing the
current printing.
Wait until warm-up ends. When it is ready, the printer starts
printing automatically.
Load the paper in the Auto Sheet Feeder of the printer and
1
select Continue* in the display on your camera.
Select Cancel in the display on your camera to cancel the print
job. Remove the jammed paper, load new media, and press the
RESUME/CANCEL button.
Close the Print Head Cover.
Install a Print Head according to the
If a Print Head has already been installed, remove it, and then
reinstall it.
If the problem still remains, the Print Head may be defective.
Contact the Customer Care Center.
is The printer has a built-in waste ink absorber to hold the ink
used during Print Head cleaning. This error message indicates
that the waste ink absorber is nearly full.
Selecting Continue*
printing. Printing can be continued for a while, but printing
cannot be continued when the waste ink absorber becomes full.
Contact the Customer Care Center as soon as possible.
Printing resumes once the Print Head Cover is closed after an
ink tank replacement.
You can continue printing by selecting Continue*
on your camera with the ink tank empty. But, it is recommended
you replace it with a new one immediately after printing. It may
damage the printer if you continue printing with empty ink
tanks.
Follow the procedure below.
1. Turn off the printer.
2. Connect the supplied Universal AC Adapter or load a charged
battery.
3. Turn on the printer.
Select Cancel in the display on your camera to cancel the print
job.
Disconnect the cable connected to the camera, turn off the
printer, and unplug the power cord of the printer from the
outlet. Leave the printer for a while, plug the power cord of the
printer back in the outlet, turn on the printer, and connect the
camera to the printer.
If the error persists, contact the Customer Care Center.
Try This
Easy Setup Instructions
1
in the display on your camera resumes
.
1
in the display