Table of Contents
Advertisement
UTILITY STITCHES AND CHARACTER/DECORATIVE STITCHES
f
If necessary, use a chalk pencil to draw a
line at the location to be sewn.
g
Start sewing.
h
After sewing the desired length, press the
"Reverse Stitch" button.
When the "Reverse Stitch" button is pressed, the
angle at the end of sewing begins to change, and the
machine stops when sewing is finished.
Memo
• If you stop sewing at the point where end
tapering should begin (either by pressing the
"Start/Stop" button or by lifting your foot from
the foot controller), press the "Reverse Stitch"
button and resume sewing by either pressing
the "Start/Stop" button or pressing on the
foot controller. End tapering will begin as
soon as sewing resumes.
i
When finished sewing, set [Tapering] to
[OFF], and then touch
7
■ Method 2: Sewing a Specified
Number of Stitch Patterns
With this method, the number of stitch patterns
(including those used to change the angle) are
specified. This allows stitch patterns of the same
length to be repeatedly sewn.
a
b
.
c
a
Refer to steps
through
Begin Changing the Angle at the End of
Sewing by Pressing the "Reverse Stitch"
Button" on page 6 to select the angle
settings for the start and end of sewing.
Touch
, and then specify the number of
stitch patterns (including those used to
change the angle).
a Approximate length of the stitch pattern
Memo
• The number of stitch patterns used to change
the angle depends on the pattern and angle.
Perform trial sewing to check the result.
Start sewing.
The machine stops automatically when sewing is
finished.
Memo
• To sew stitching in a square, select
the start of sewing and
sewing, and then continue sewing the same
stitch pattern, rotating the fabric 90° after
sewing each line of stitching.
The pivot setting is useful when changing the
sewing direction. For details, refer to
"Pivoting" in the machine's Operation Manual
(Sewing).
d
of "Method 1:
a
for
for the end of
Advertisement
Table of Contents
