Brother Upgrade KIT III Operation Manual page 23

g
Rehoop the fabric. Adjust the position and
angle for the next pattern so that the
alignment stitching embroidered with the
first pattern and the needle position for the
next pattern are aligned. For this example,
touch , select the upper-left needle
position, and then touch
Memo
• For best results, if fabric puckers, iron the
wrong side of the fabric to smooth out before
rehooping.
h
Touch
and angle for the next pattern so that the
needle position is aligned with the
alignment stitching embroidered with the
first pattern.
*
.
*
a Alignment stitching
i
In the same way, select the lower-left
needle position, and then adjust the
position and angle of the next pattern so
that the needle aligns with the thread mark
embroidered with the first pattern.
j
Embroider the second pattern.
k
Embroider the remaining patterns in the
same way as with the second pattern.
l
Remove the thread marks.
, and then adjust the position
To adjust the position of the pattern, touch
To adjust the angle of the pattern, touch
EMBROIDERY
.
.
a
22