Bosch GCM18V-10SD Operating/Safety Instructions Manual page 41

3. Adjust your left or right bevel stop indicator
(33) to one of the three pre-set locations,
33.9°, 45°, 47°, or tilt the head assembly
(Fig. 47, 28) until you reach the desired
angle on your bevel scale (Fig. 49 and Fig.
50, 10).
NOTE: To bevel the saw to the right, the
Bevel Range Selector Knob must be pulled
forward (Fig. 50, 11).
4. Lock the bevel by rotating the bevel lock
knob (34) counterclockwise.
5. Follow either the procedure "Chop Cuts" on
page 37 or "Slide Cuts" on page 38.
Fig. 49
Watch while tilting to right
"30" position for
cutting 45° "spring
angle" crown molding
flat on table
16099221PJ GCM18V-10SD OSI 20220506.indd 41
Saw Operations
Fig. 50
Bevel scale information
"33.9" positions are for cutting 38°
"spring angle" crown molding flat
on table
NOTE: Saw has a 33.9 detent
feature to automatically hold it at
this bevel angle setting
-41-
10
11
Watch while tilting to left
34
33
5/6/22 11:42 AM