Assembly; Storing The Torx Wrench; Attaching The Miter Lock Knob - Bosch GCM18V-10SD Operating/Safety Instructions Manual

To avoid possible injury, disconnect battery pack before performing any as-
sembly, adjustments or repairs.

Storing the Torx Wrench

There is a storage location on the saw to store
the Torx wrench (Fig. 7, 41). Insert the short leg
of the Torx wrench through the rubber grommet
as shown. Place the long leg into the tool rest.
NOTE: The Torx wrench (41) is needed to
change the blade and to attach the side exten-
sions. If lost, use a Torx 30 wrench or a key.
Fig. 7
41
16099221PJ GCM18V-10SD OSI 20220506.indd 18

Assembly

Attaching the Miter Lock Knob

1. Locate the miter lock knob (20) from among
the loose parts.
2. Look under the turntable's front arm, below
the miter detent override button (Fig. 8, 21),
and locate the 10mm hole.
Fig. 8
3. Insert the long shaft of the miter lock knob
through this hole until it stops.
4. Turn the knob clockwise (about 8 full revolu-
tions) until it is tight or "locked."
5. Loosen the knob 1/2 turn to unlock it. The
table is now free to be moved on the base.
-18-
21
5/6/22 11:42 AM