Setting A Password; Registering A Password - Canon REALiS WUX10 Mark II User Manual

Setting Various Function

Setting a Password

[Other settings] - [Password settings]
HDMI
DIGITAL PC
ANALOG PC
Other settings
Password settings
Disables the projector unless the correct pass-
word is entered.
Off The projector can be used even if no password
is entered.
On The projector cannot be used unless you enter
your password.
Press the OK button to accept your setting and
then press the MENU button.
• [Off] is the factory default.
• You cannot set [On] unless you have com-
pleted [Register password].
Once you set a password, the password entry
screen appears at power-on.
Enter a 4-digit password with [ ] / [ ] / [<] / [>].
If the password is valid, the projection starts. If
you enter a wrong passwords three times, the
power will be turned off.
• The power is also turned off if no password is
inputted for 3 minutes.
To Cancel the Password
Turn off the projector and unplug the power
plug. Hold down the MENU button on the top
control and connect the power plug. Make
sure to keep holding down the MENU button
until a beep sounds. The password is can-
celled (the registered password is also reset).

Registering a Password

[Other settings] - [Register password]
COMPONENT
VIDEO
System settings
You can register a password for starting
projection.
Press the OK button after selecting [Reg-
ister password], and the following screen
for registering a password appears:
Enter a 4-digit password using [ ] / [<] /
[ ] / [>] (e.g.,
The 4-digit password is entered from the
left to right digits, the password is auto-
matically registered.
• Press the MENU button to abort the reg-
100
HDMI
DIGITAL PC
ANALOG PC
Other settings
Register password
, <<<<,
istration.
COMPONENT
VIDEO
System settings
<>).