Parking Mode - Pioneer VREC-Z710SH Owner's Manual

Parking Mode

When the power supply to this product is turned off (vehicle engine is turned off), Parking Mode is
activated for a fixed period of time. The maximum operation time is approximately 40 minutes.
When this device detects vehicle movement caused by vibration while Parking Mode is activated, that
event is saved for 20 seconds before and 20 seconds after the moment of detection as a parking mode
file, and a notification message is displayed at the next startup.
Notes
• Parking Mode can be set to on or off. The operation time of Parking Mode can also be set.
→
"This Product Settings" - "Configurable Features" - "Values" - "Parking Mode" - "Parking
Mode Video Length"
• You can adjust the sensitivity for detecting vibration.
→
"This Product Settings" - "Configurable Features" - "Values" - "Parking Mode" - "G-Sensor
Sensitivity"
• Vibration that is detected for approximately three minutes after power supply to this device is
stopped and for approximately three minutes before power supply is started is not covered by the
notification message display feature.
• The recording time may differ depending on the conditions.
Security Mode
If the pre-set operation time elapses when Security Mode is turned ON, Security Mode, parking
surveillance operates continuously, is automatically activated.
When this device detects vehicle movement caused by vibration while Security Mode is activated,
that event is saved for one minute after the moment of detection as a parking monitoring file, and a
notification message is displayed at the next startup.
Notes
• Security Mode can be set to on or off.
→
"This Product Settings" - "Configurable Features" - "Values" - "Parking Mode" - "Security Mode"
• In Security Mode, this product runs in the low power consumption mode to reduce the risk of the
battery going dead.
• Security Mode starts recording within three seconds of detection of impact.
• Vibration that is detected for approximately three minutes before the vehicle's engine is turned on
(ACC ON) is not covered by the notification message display feature.
• Security Mode is a feature for starting up and activating this product after an impact is detected.
For this reason, the battery might wear more quickly if this product is used in multi-story parking
garages or the location subjected to lots of vibration. When parking in locations such as these, set
Security Mode to off before using this product.
• The recording time may differ depending on the conditions.
About the Voltage Monitoring Function
When using Parking Mode, first configure the
automatically prevents the battery from becoming depleted when the vehicle's battery voltage falls
below a set voltage value.
→
"This Product Settings" - "Configurable Features" - "Values" - "Parking Mode" - "Voltage
Monitoring"
When the
"Parking Mode Video Length"
setting is ON
When the voltage drops to the voltage value set in
Parking Mode, and instead activates Security Mode.
When the voltage drops below the voltage value set in
the device operation is stopped (power is turned off).
"Voltage Monitoring"
setting is other than OFF, and the
"Voltage Monitoring"
"Voltage Monitoring"
− 32 −
settings. This function
"Security Mode"
+0.1 V or lower, this stops
during Security Mode,