NS-PMMD22 Introduction Congratulations on your purchase of a high-quality Insignia product. Your NS-PMMD22 represents the state of the art in monitor mount design and is designed for reliable and trouble-free performance. IMPORTANT SAFETY INSTRUCTIONS 1 Make sure these instructions are read and completely understood before attempting installation. If you are unsure of any part of this installation, please contact a professional installer for assistance.
Package contents Parts Make sure that you have all the parts necessary to assemble your new monitor mount: Cable support brackets (pre-installed) PART QTY. PART QTY. Tube cover Support base Monitor support arm Base clamp Monitor support tube Anti-slip rubber pads Hardware Make sure that you have all the hardware necessary to assemble your new monitor mount: A M4 x 12 mm (8)
NS-PMMD22 Installation instructions STEP 1: Preparing your monitors 1 Make sure that your monitors have screw holes on the backs for VESA mounting. You can use monitors with VESA mounting patterns of 75 × 75 mm (3 × 3") or 100 × 100 mm (3.9 × 3.9").
Page 6
2 Determine which mounting holes to use, based on the thickness of your desk. Insert two M6 x 10 mm screws (D) through the base clamp (5), then tighten the screws using the 4 × 4 Allen wrench (F). Place the anti-slip rubber pads (6) on the tops of the clamp screws.
NS-PMMD22 STEP 3: Attaching the monitor support arm Note: The monitor support arm is one piece, so both monitors will be at the same height. As you decide where to position the monitor support arm, remember the tops of the monitors should be level with your eyes.
STEP 4: Attaching the monitors Note: Monitors can be oriented either horizontally or vertically. Depending on the VESA screw holes on the back of your monitors, you need to use the M4 × 12 mm mounting screws (A) or the M5 × 12 mm mounting screws (B). 1 Determine which mounting screws you need (A or B) by hand-threading a screw into a VESA screw hole.
NS-PMMD22 STEP 5: Adjusting the monitors and managing the cables To avoid eye strain: • Position your monitors about an arm’s length from your eyes. • Position your monitors so there is no glare on the screens from windows or light sources.
During the Warranty Period, if the original manufacture of the material or workmanship of the Product is determined to be defective by an authorized Insignia repair center or store personnel, Insignia will (at its sole option): (1) repair the Product with new or rebuilt parts; or (2) replace the Product at no charge with new or rebuilt comparable products or parts.
Page 11
For product inquiries, please contact us with the information below: 1-877-467-4289 www.insigniaproducts.com INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC V1 ENGLISH 7601 Penn Ave South, Richfield, MN 55423 U.S.A. 22-0240...