Canon Optura Instruction Manual page 39

To use the conversion program, put the camera in record pause mode and turn the
program selector to
You can also alter the strength and tint of the colors, plus mask the edges of the
picture when using the Film Adapter (FP-100).
1. Display TINT, COLOR and MASK. options by moving the
controller up or down.
2. Adjust the level or choose the type of masking by pressing the
controller up or down to choose the option and then left/right to
change its setting.
Tint:
• There are 15 possible settings. When converting a negative image, around
setting 5 gives the converted image the most reddish tint, around 10 gives the
most bluish tint.
Color:
• The settings for the overall strength of the colors varies from +5 to –5. Setting
–5 gives a black and white image. Use this when converting black & white
negatives.
• When you adjust the tint or color,
• When you select a different recording program or switch the power off , the tint
and color will return to a level set automatically by the camcorder and the
will disappear from the display.
• Also, when you change the film you need to return the tint and color to the
automatic levels in the same way.
Masking:
• There are 6 masking settings, three portrait
(vertical) maskings and 3 landscape
(horizontal) maskings.
• and correspond to the Advanced
2
2
Photo System, the others to 35 mm film.
• The options disappear from the frame a
few seconds after your last operation.
Note:
• The camera mode is set to progressive scan by the camera; you cannot select
normal mode.
.
appears in the display.
M
No display
MASK .
.
MASK
3
.
. MASK
MASK
2
M
1 MASK . 2
MASK . 3
No display
1
39
E