Contact Information - Brother P-touch PT-D410 Quick Start Manual

Hide thumbs Also See for P-touch PT-D410:

User manual (120 pages)

Manual (8 pages)

Table Of Contents

Table of Contents

Problem

Solution

Printed barcodes or QR

• Change the tape. (Recommended: Black on white tape)

codes cannot be read.

• Enlarge the barcodes or QR codes using the barcode application,

if possible.

I do not know the firmware

Confirm the firmware version by pressing the following keys:

version of the Label

Maker.

When the label is printed,

• Refer to the Set Margins section in this guide and select [Small

there is too much margin

Margin] [Chain] or [No Cut] for smaller margins.

(space) on both sides of

When you set [Small Margin], the label maker feeds approx. 0.9"

the text.

(23 mm) of leader tape before every new label.

To save tape, set the [Chain] setting. After the last label prints,

press

Cutter Lever.

• The Label Maker feeds approx. 0.9'' (23 mm) of tape before every

new label. When printing multiple labels, you can reduce the blank

space on the second and subsequent labels.

Select the [Chain] setting in the optional print settings. Then, print

your labels and leave the last label in the Label Maker until you are

ready to print a new label.

• After the last label prints, press

feed the tape, and then eject and cut the last label. Note that the

Label Maker will feed approx. 0.9'' (23 mm) of tape before the next

new label when you use this method.

The font size cannot be

The font is already the maximum size for the width of the label. Or,

increased.

the label length has been set, so there is a limit on the font size to

prevent exceeding the set length.

When multiple labels are

When Chain Print is enabled, feed the tape to eject the last printed

printed, the last label is cut

label, and then press the Tape Cutter Lever to cut the label manually.

incorrectly.

[Version Information]

and

to feed the tape, and then press the Tape

and

simultaneously to

Troubleshooting (cont.)

Problem

Solution

I cannot update the printer's

Restart the printer and then try to update the firmware again. Do not

firmware using the P-touch

press any buttons during the firmware update.

Update Software, Transfer

Express, or Mac Update

Tool.