Before Machine Start-Up - Viper ROS1300 Instructions For Use Manual

INSTRUCTION FOR USE

BEFORE MACHINE START-UP

Checklist
1. Have a full knowledge of the machine operating controls and
their functions.
2. Sit on the seat (A, Figure 9), insert the ignition key (C, Figure
9), and start the machine. (See the procedures in the following
paragraph)
3. Check the battery level. If the battery icon on the LCD (G,
Figure 9) is of 5 bars, the batteries are fully charged for use. If
it is of 1 bar or less, batteries must be charged before operation.
(Refer to Maintenance chapter for battery charging)
4. Check the parking brake (F, Figure 9). The brake must hold its
setting (locked) firmly without easily being released (report all
defects immediately to Nilfisk Service Center).
5. Check the flap pedal (E, Figure 9) for proper operation.
6. Press the accelerator pedal (D, Figure 9) slightly then release it
to check if the machine can be steered forward and stopped.
7. To ensure safety, confirm the machine can be stopped
immediately when pressing the emergency stop button (B,
Figure 9). Turn the emergency stop button to reset it.
WARNING!
If the pedal is "spongy" or fades under pressure
without an efficient braking force, do not drive
the machine (report all defects immediately to
Nilfisk Service Center).
8. Make sure that there are no open covers/hoods and that the
machine is in normal operating conditions.
9. Make sure that the hopper (H, Figure 9) is properly closed.
Cleaning planning
1. Arrange long runs with a minimum of stopping or starting.
2. Allow a small amount of broom path overlap to ensure complete coverage.
3. Avoid making sharp turns, bumping, or scraping the side of the machine.
GEL
G
A
B
C
D
H
15
ENGLISH
0000.H GEL 0000.H
Figure 9
E
F