Table of Contents
Advertisement
RF supervision
Receiver terminal S activates whenever the receiver goes
one or four hours without receiving a signal from a
supervised transmitter. To monitor for RF supervision,
connect the receiver S output to a control panel zone input.
Panic buttons and wireless sensor
Panic buttons
Use zone 1 for up to 45 unsupervised panic button
transmitters. Use zones 2 to 8 for supervised panic button
transmitters (2 per zone).
Wireless sensors
Learn wireless sensors into remaining unused zones (2 per
zone). Make sure that both sensors learned into the same
zone have the same expected response type at the control
panel (delay, instant, interior, 24-hour).
Use Table 2 to record the wireless devices used for each
zone.
Table 2: Transmitter zone assignments
Receiver zone
Panel zone
1
2
3
4
5
6
7 (RF jam detect)
8 (Tamper detect)
B
S
Receiver programming
This section describes the following programming
procedures:
6 / 10
Transmitter
Function
•
Learning wireless transmitters
•
Deleting wireless transmitters
•
Configuring zone/trouble outputs N/O or N/C
•
Configuring RF supervision
•
Configuring keychain touchpad zone output
Learning wireless transmitters
To learn a transmitter into a zone, do the following:
1.
To enter program mode, slide the DIP switch up. The
low battery and supervisory LEDs blink back and forth.
2.
Press and release the ADV switch until the desired zone
LED turn on. (If you press and hold the ADV switch, you
will advance to the next zone and cause the zone LED
to flicker.)
3.
Press and release the SEL switch once to select this
zone for learning transmitters. The zone LED remains on
and the low battery and supervisory LEDs stop flashing.
4.
Trip the transmitters:
•
For sensors with tamper switches, remove the
cover.
•
For sensors without tamper switches, put the sensor
in alarm. Each time the receiver learns a sensor, the
selected zone LED blinks once.
•
For keychain touchpads:
•
Zone 1, press the lock and unlock buttons
together.
•
Zone 2, press the lock or unlock button.
•
Zone 3, press the lights button.
•
Zone 4, press the star button.
•
Zone 5, press the lock button.
•
Zone 6, press the unlock button.
Each time the receiver learns a keychain touchpad
button, all zone LEDs with learned keychain touchpads
blink once.
5.
To stop learning transmitters in the selected zone, slide
the DIP switch down.
Repeat the procedure to learn transmitters into another zone.
Deleting wireless transmitters
To delete all transmitters from a zone, do the following:
1.
To enter program mode, slide the DIP switch up.
2.
Press and release the ADV switch until the desired zone
LED turns on.
3.
Press and hold the SEL switch for five seconds to delete
all transmitters from this zone. The zone LED should
turn off.
P/N 466-1452 • REV E • ISS 16OCT18
Advertisement
Table of Contents
