Table of Contents
Advertisement
Tools and accessories needed
The following tools and accessories are included with the
receiver:
•
Mounting screws and anchors
•
Spring for tamper switch
•
Antenna
The following tools and accessories are needed to install the
receiver, but are not included with the receiver:
•
Phillips screwdriver
•
Small standard screwdriver
•
12 to 22 gauge stranded wire
•
Optional piezo for sensor testing
•
12 VDC power supply (typically supplied by panel)
•
EOL resistors (typically supplied with panel)
Installation
Observe the following guidelines when installing the receiver:
•
Leave 10 in. (25 cm) above the receiver for the antenna.
•
Avoid areas that may expose the receiver to moisture.
•
Avoid areas with excessive metal or electrical wiring,
including furnace and utility rooms. Or, if unavoidable,
mount on metal with the antenna extending above the
metallic surface (see Figure 5).
•
Do not install within 3 meters of another receiver.
Caution:
Do not install wireless sensors within 31 cm of the
Quik Bridge receiver.
Figure 5: Mounting on metal
Metal
To mount the receiver, do the following:
1.
To remove the receiver cover, press down on the top
center of the cover (see Figure 6) and pull the cover
away from the base.
4 / 10
Metal
Figure 6: Remove the cover
Caution:
You must be free of static electricity before
handling circuit boards. Touch a bare metal surface or wear
a grounding strap before handling circuit boards.
2.
Press the lower right corner of the base until the lower
right latch releases the circuit board (see Figure 7).
Figure 7: Latches and mounting holes
Mounting
hole
Top latch
Mounting hole
3.
To remove the circuit board, pull it away from the two top
latches and set it aside.
4.
Hold the base against the mounting surface and mark
the three mounting holes (Figure 7: Latches and
mounting holes). Leave at least 10 in. (25 cm) above the
base for the antenna.
5.
Remove the base and install the anchors provided, if
studs are not present.
6.
Mount the base on the wall with the screws provided.
7.
To replace the circuit board on the base, slide the top of
the circuit board under the top two latches, then press
the bottom of the circuit board until it snaps under the
lower right latch.
Connecting the antenna to the receiver
To connect the antenna to the receiver, do the following:
Top latch
Lower right latch
Mounting hole
P/N 466-1452 • REV E • ISS 16OCT18
Advertisement
Table of Contents
