Recording Discs-Disc Synchronized Recording - JVC FS-B70 Instructions Manual

Recording Discs
—Disc Synchronized Recording
You have three methods to record from discs onto a tape.
Using the synchronized recording methods, you can start and
stop disc play and recording at the same time.
• One Disc Synchronized Recording—Records the entire
disc.
• All Discs Synchronized Recording—Records all loaded
discs continuously (Continuous Play) or at random
(Random Play), or the program you have made (Program
Play). See page 23.
• First Track Recording—Records the first track of each
disc. See page 24.
• One Track Recording—Records just the track you want
during play. See page 24.
• Set the Reverse Mode and the tape direction properly to
record on both side of the tape. (See page 21.)
If the front side of the tape ends in the middle of a track, the
recording on the reverse side starts from the beginning of that track
(if the reverse mode is set to
However, when recording in the Random Play mode, recording on
the reverse side does not starts from the beginning of the track.
"NO REC" will appear on the display when you press
REC in the following cases:
• If no cassette is inserted.
• If a protected tape is inserted.
• If any tray is open when the source is the CD player.
One Disc Synchronized Recording
1
Insert a recordable cassette into the cassette
compartment with the exposed part of the
tape facing left.
2
Load the disc you want to record into the 5-
CD Changer.
3
Press the disc number button (CD
1 – CD 5) on the remote control to
select the disc you want to record,
then press 7.
).
CD 1
CD 2
CD 3
CD 4
CD 5
4
Press CD REC MODE on the remote
control to select "1 CD."
Each time you press the button, the recording
mode changes as follows:
1 CD ALL CD
1 2 3 4 5
CD
5
Press REC while "1 CD" still
remains on the display.
The indicator lights up on the display and
REC
recording starts.
• Make sure to press the button before "1 CD" goes off;
otherwise, recording will start in the All Discs
Synchronized Recording mode (see page 23).
1 2 3 4 5
CD
Current track
number
When the selected disc is recorded, recording will stop. Both
the 5-CD changer and the cassette deck stop automatically.
To stop while recording, press 7.
The tape stops after 4 seconds.
To remove the cassette, press 0 on the unit.
When recording a disc
A 4-second blank is automatically made on the tape before each
track. To record without the blank, follow the procedure below:
1 Load only the disc you want to record into the 5-CD Changer.
2 Press DISC SELECT on the unit to select the disc number you
have loaded.
3 Press #/8 CD on the unit twice so that disc playback is paused.
• If the pausing position is not "0:00," you can skip back to
"0:00" by pressing 4 DOWN on the unit.
4 Press REC on the unit to start recording.
When the disc is recorded, recording will stop.
You cannot exchange a disc while recording another disc.
Pressing CD REC MODE changes the disc playback mode to
Continuous Play and cancels the Repeat Play mode.
Continued
CD REC
MODE
1ST TRACK
REC
REC
Elapsed playing
time
TAPE
22