2Type 2 Battery Holder - HP Compaq dx2000 ST Series Reference Manual
Business desktop
Hide thumbs
Also See for Compaq dx2000 ST Series:
- Reference manual (2 pages) ,
- Quick setup manual (26 pages) ,
- Supplementary manual (2 pages)
Table of Contents
Advertisement
Removal and Replacement Procedures— Slim Tower (ST) Chassis
6.13.2 Type 2 Battery Holder
1. To release the battery from its holder, squeeze the metal clamp that extends above one edge
of the battery 1. When the battery pops up, lift it out.
2. To insert the new battery, slide one edge of the replacement battery under the holder's lip 2
with the positive side up. Push the other edge down until the clamp snaps over the other edge
of the battery.
After the battery has been replaced, use the following steps to complete this procedure.
3. Replace the computer cover or access panel.
4. Plug in the computer and turn on power to the computer.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
Refer to the Computer Setup (F10) Utility Guide.
6–26
371411-001
Service Reference Guide, dx2000 ST
Advertisement
Table of Contents
