carefully.
Note
Do not use a soldering iron or de soldering tool of more than 30
watts on DPC contacts
9.5. Fan Motor
1. Remove two screws and remove the tie bar
2. Disconnect the two lead wires from the fan motor terminals
3. Disconnect all lead wires from the noise filter
4. Remove the noise filter
5. Remove the air guide by removing the two screws
6. Remove the two screws holding the orifice assembly
7. Remove the two screws holding the fan motor assembly
8. Detach the orifice assembly and the fan motor assembly from the
oven assembly.
9. Remove the fan blade from the fan motor by pulling outward.
9.6. Door disassembly
1. Remove door C from door E by carefully pulling outward starting
from the upper right hand corner using a flat blade screwdriver.
2. Remove four screws holding the door E to the door A assembly
3. Remove the door screen B by carefully un-clipping the screen
from the door A catch hooks. Care must be taken not to damage
Figure 6
Removing the fan motor
32