Accessing Dps Through Computer Setup - HP Compaq dc7800 USDT Troubleshooting Manual

Accessing DPS Through Computer Setup

When the computer does not power on properly you should use Computer Setup to access the DPS
program. To access DPS, perform the following steps:
1. Turn on or restart the computer.
2. When the F10 Setup message appears in the lower-right corner of the screen, press the
NOTE:
computer off, then on again, to access the utility.
A choice of five headings appears in the Computer Setup Utilities menu:File, Storage, Security,
Power, and Advanced.
3. Select Storage > DPS Self-Test.
The screen will display the list of DPS-capable hard drives that are installed on the computer.
NOTE:
the screen.
4. Select the hard drive to be tested and follow the screen prompts to complete the testing process.
When the test has been completed, one of three messages will be displayed:
●
Test Succeeded. Completion Code 0.
● Test Aborted. Completion Code 1 or 2.
● Test Failed. Drive Replacement Recommended. Completion Code 3 through 14.
If the test failed, the completion code should be recorded and reported to your service provider for help
in diagnosing the computer problem.
ENWW
If you do not press the
If no DPS-capable hard drives are installed, the DPS Self-Test option will not appear on
F10 key while the message is displayed, you must turn the
Accessing DPS Through Computer Setup
F10 key.
63