Solving Media Card Reader Problems - HP Compaq dc7800 USDT Troubleshooting Manual

Solving Media Card Reader Problems

Table 2-5 Solving Media Card Reader Problems
Media card will not work in a digital camera after formatting it in Microsoft Windows XP or Microsoft Windows Vista.
Cause
By default, Windows XP and Windows Vista will format any
media card with a capacity greater than 32MB with the FAT32
format. Most digital cameras use the FAT (FAT16 & FAT12)
format and can not operate with a FAT32 formatted card.
A write-protected or locked error occurs when attempting to write to the media card.
Cause
Media card is locked. Locking the media card is a safety feature
that prevents writing to and deleting from an SD/Memory Stick/
PRO card.
Can not write to the media card.
Cause
The media card is a read-only memory (ROM) card.
Unable to access data on the media card after inserting it into a slot.
Cause
The media card is not inserted properly, is inserted in the wrong
slot, or is not supported.
Do not know how to remove a media card correctly.
Cause
The computer's software is used to safely eject the card.
After installing the media card reader and booting to Windows, the reader and the inserted cards are not recognized
by the computer.
Cause
The operating system needs time to recognize the device if the
reader was just installed into the computer and you are turning
the PC on for the first time.
ENWW
Solution
Either format the media card in the digital camera or select FAT
file system to format the media card in a computer with
Windows XP or Windows Vista.
Solution
If using an SD card, make sure that the lock tab located on the
right of the SD card is not in the locked position. If using a
Memory Stick/PRO card, make sure that the lock tab located
on the bottom of the Memory Stick/PRO card is not in the
locked position.
Solution
Check the manufacturer's documentation included with your
card to see if it writable. Refer to the previous section for a list
of compatible cards.
Solution
Ensure that the card is inserted properly with the gold contact
on the correct side. The green LED will light if inserted properly.
Solution
Open My Computer (Windows XP) or Computer (Windows
Vista), right-click on the corresponding drive icon, and select
Eject. Then pull the card out of the slot.
NOTE: Never remove the card when the green LED is
flashing
Solution
Wait a few seconds so that the operating system can recognize
the reader and the available ports, and then recognize
whatever media is inserted in the reader.
Solving Media Card Reader Problems 21