Advertisement
1. Px7 S2 Carton Contents
Px7 S2 over-ear wireless headphones
Storage case
USB-C to USB-C charging cable
USB-C to 3.5 mm audio cable
Document pack
2. Getting to Know Your Px7 S2
We recommend installing the
Bowers & Wilkins Music app on your iOS or Android
device. This allows
you to configure your
headphones in detail and
provides helpful hints and
tips to make the most of
your new headphones.
bowerswilkins.com/downloadapp
2.1 Switching Headphones On and Off
Diagram 1 illustrates power switch functionality.
Switching On
The power switch is located on the right earpiece.
Slide the power switch up to the middle position. An
audible cue will be played and the LED indicator will
light up.
Switching Off
Slide the power switch to the bottom position. An
audible cue will be played and the headphones will
power down when the LED indictor is no longer lit.
Bluetooth Pairing
Slide the power switch to the upper position and
hold for 5 seconds to enter Bluetooth pairing mode.
Refer to section 6 for further information on pairing
your headphones to a Bluetooth source.
2.2 Headphone Controls
Diagram 2 illustrates the headphone controls. The
buttons on the right earpiece are used for media
playback and telephony.
Media Playback
Function
Action
Press the Multi-function button once.
Play or pause
Press the Multi-function button
Play next
twice in quick succession. Note:
track
functionality dependent on source
device.
Press the Multi-function button three
Play previous
times in quick succession. Note:
track
functionality dependent on source
device.
Increase Volume
Press the Volume + button.
Lower Volume
Press the Volume - button.
Telephony
Function
Action
Answer an
Press the Multi-function button once.
incoming call
End a call
Press the Multi-function button once.
Hold the Multi-function button for 2
Decline an
incoming call
seconds.
Switch between
With two calls active, press the Multi-
two calls
function button twice.
With two calls active, hold
Merge two calls
the Multi-function button for
1 second.
While on a call, press the Multi-
Toggle mute
function button three times.
2.3 Status Indicator
The status LED indicator is located on the right
earpiece, the table below explains the illumination
states:
Illumination
Operational state
White
Battery charge > 30%
Amber
Battery charge between 30% and 10%
Battery charge < 10%
Red
Red flashing
Battery charge insufficient for headphone operation
Blue flashing
Pairing mode enabled
Blue (2 sec solid)
Pairing successful
Blue flashing (calls)
Incoming call
Green flashing
Rapid charging
Battery charge full, trickle charging
Green solid
Diagram 1
Power switch functionality
Quick Action button
Diagram 2
Headphone controls
Power switch
Volume +
Multi-function
Volume -
3
Advertisement
