9 Secure the device in position using the screws provided with it.
10 Connect the power and data cables to the rear of the device. The power connector is shaped to fit one way only. Refer
to the drive's manual(s) for the orientation of the data connector. Refer to
more information about which connectors to use.
11 If the system board drawer was pulled out, slide it back into the computer chassis.
12 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables.
13 Turn on the display and then turn on the computer. In Windows, check that the new drive has been recognized: double-
click the My Computer icon on the desktop and check that the new drive is there.
Depending on the type of drive you have installed, you may need to install some driver software.
3 Upgrading and Adding Accessories
"System Board Connectors" on page 57
Adding Accessories
for
63