Table of Contents
Advertisement
r Angle sensor
The range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.
Parts for installation (optional)
The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings)) and Ceiling Mount Bracket (Model No.:
ET-PKD130B (Projector Mount Bracket)).
f Be sure to use the Ceiling Mount Bracket specified for this projector.
f Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.
Attention
f To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualified
technician.
Projected image and throw distance
Install the projector referring to the projected image size, projection distance, etc.
Attention
f Before setting up, read "Precautions for use" ( x page 19).
f Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
Figure of projected image and throw distance
Note
f This illustration is prepared on the assumption that the projected image size and position have been aligned to fit full in the screen.
f This illustration is not in accurate scale.
34 - ENGLISH
Chapter 2 Getting Started — Setting up
Floor standing installation
Floor standing installation
Projection direction
Projected image
SW
30°
Ceiling mount installation
30°
Screen
L (LW/LT)
L (LW/LT)
Screen
Advertisement
Table of Contents
