Recovering The Unit - Bosch DIVAR IP DIP-73GC-16HD Installation Manual

30 en | System setup
12. Click Next to continue.
13. Apply the following settings:
14. Click Create Virtual Drive.
15. Click Next to continue.
16. Check the settings for the virtual drive configuration.
17. Click Finish to accept the settings and to complete the configuration.
18. Exit the MegaRAID Storage Manager application.
19. Perform a complete system recovery (Initial Factory Setup).
8.4.2

Recovering the unit

Following procedure describes how to restore the factory default image.
To restore the unit to factory default image:
1.
2.
Notice!
i
Do not turn off the unit during the process. This will damage the recovery media.
3.
4.
5.
2021.10 | V02 | DOC
The Create Virtual Drive - Virtual drive settings dialog box is displayed.
– Initialization state: Fast Initialization
– Strip size: 64 KB
– Write policy: Always Write Back
Note: Keep all other settings unchanged.
The virtual drive is created.
The Create Virtual Drive - Summary dialog box is displayed.
The virtual drive will be created and initialized.
Start the unit and press F7 during the BIOS power-on-self-test to enter Windows PE.
The Recovery menu is displayed.
Select one of the following options:
– Initial Factory Setup (all data on system will be lost): This option deletes data on all
HDD partitions and overwrites the operating system partition with the factory default
image.
– Initial Factory Setup (overwriting existing data): This option deletes and overwrites
data on all HDD partitions. Furthermore, it overwrites the operating system partition
with the factory default image.
Note: This procedure might take very long.
– System Recovery (back to Factory Defaults): This option overwrites the operating
system partition with the factory default image and imports existing virtual hard
drives from the HDDs during recovery.
Note:
The System Recovery option does not delete video footage that is stored on the data
HDDs. However, it replaces the complete operating system partition (including the video
management system settings) with a default configuration. To access existing video
footage after recovery, the video management system configuration needs to be exported
before the system recovery and re-imported afterwards.
The unit starts from the recovery media. If the setup is successful, press Yes to restart
the system.
Windows performs the initial setup of the operating system.
After Windows has completed the setup, the unit restarts.
After the restart of the unit, the factory settings are installed.
Installation manual
DIVAR IP all-in-one 7000 3U
Bosch Security Systems B.V.